Rectangular Trampoline Bed
If your old trampoline bed is in suitable condition we prefer you supply the measurements requested below.
Please Note :
If your old trampoline bed has a hole, do not measure across or near hole. If hole jeopardizes measurement, please measure your frame & springs and do not use this instruction set.
Bed can be measured while assembled or while laying on a flat surface. If measured off the trampoline, pull the bed flat while measuring.
The measurement diagram below refers to "triangles" but the perimeter of your bed may have another type of hardware. Measure to the outside point of your hardware, regardless of hardware type.
Four corner configurations are common on rectangular beds. Select your type to view measurement instructions below.
Normal - Springs butt up on each side of corner. This is the most common corner configuration in rectangular trampoline beds.
Normal with Diagonal - In addition to the springs on each side of the corner, there is an extra spring mounted diagonally. These extra corner springs are typically longer than other springs.
Diagonal Only - Each corner has only a diagonal spring with no additional springs on each side of the corner. These corner springs are typically longer than other springs.
Crowded - Springs are spaced evenly along the bed’s sides except close to the corners. Beside each corner, the first and third springs are crowded close to the second spring.
Please Fill in the Following Order Form :
Price: (Free Shipping)
Select measuring unit
Select
1.Width
2.Length
3.Springs along length
4.Springs along width
5.Bed Fabric Options
6.UV Protection Options
7.Quantity
8.Price
Price above computed based on options selected.