Please Note :

If your old trampoline mat has a hole, do not measure across or near hole. If hole risks measurement or if replacing most or all the springs, please measure your frame & springs and do not use this instruction set.

Mat can be measured while installed or while laying on a flat surface. If measured off the trampoline, pull the mat flat while measuring.

Four corner configurations are common on rectangular mats. Select your type to view measurement instructions below.

Normal - Springs butt up on each side of corner. This is the most common corner configuration in rectangular trampoline mats.

Normal with Diagonal - In addition to the springs on each side of the corner, there is an extra spring mounted diagonally. These extra corner springs are typically longer than other springs.

Diagonal Only - Each corner has only a diagonal spring with no additional springs on each side of the corner. These corner springs are typically longer than other springs.

Crowded - Springs are spaced evenly along themat’s sides except close to the corners. Beside each corner, the first and third springs are crowded close to the second spring.

: